Auto-on within 10ft (3m), auto-off after about 20 seconds of no motion detected. With 2 Sensor Modes, it can detect the motion of human in the dark or daytime.
My guess is that this is true of most LED dimmers, and this is needed because LED loads can be way lower then incandescent loads. The LED dimmer I have has a setting inside it to make adjustments depending on load. If the circuits are not compatible with the dimmer, it could cause them to not work correctly or fail early. Depending on the manufacturer this circuitry can be quite different. Mains rated LED bulbs have circuitry in them to handle dimming. This means it is electrically safe, in as much as you are not going to have heat buildup which the dimmer can't handle. (Assuming the total load is less then 600 watts, ie the wattage in actual watts the dimmer consumes, not the "incandescent equivalent brightness - and as you are using LEDs thats a fairly safe assumption) The load is less then the dimmer is capable of handling. My guess is that this is fine to do if it works, but if there is annoying flickering you should drive the dimmer on full until you can get a replacement. Worst case scenario is the bulbs will fail sooner then they would be expected to. That said, yes, this is safe provided the LED lights are rated at 100 watts or less each. I don't think anyone can advise you with certainty if this is a good idea, except maybe the manufacturer. Are there any electrical risks to using LED bulbs on a this type of dimmer switch? Any commentary guidance would be welcome. My dimmer model does not say that it is LED compatible, the manual for the Lutron AY-603P dimmer switch says that it can be used with halogen and incandescent lights, it doesn't say anything about LED lights. Is this safe? I had read that I should only use LED approved dimmer switches with LED bulbs. The LED bulbs I ordered are dimmable so I decided to try them out and they seem to work just fine on my dimmer switch, no buzzing or flickering. The lights needed replacing so I ordered some new ones, however, I accidentally ordered these LED bulbs instead. Up until now I have had fluorescent lights in them. My kitchen has six floodlights on a Lutron toggler dimmer switch, model AY-603P. I have a question about dimmer switches for LED flood lights.
0 kommentar(er)
